Great Plains NP4000B Operator Manual - Manual (Page 87)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 83
2014-05-14 Table of Contents Index 417-199M
Suspending Application Checklist Page
1 Liq: Set hydraulic pump circuit to Float.
2 Set console MASTER switch OFF 69
3 NH
3
: Continue application until flow
divider pressure is 0
69
4 NH
3
: Turn into the wind -
5 NH
3
: Stop tractor, with tines in ground 69
6 Liq: Stop tractor, with applicator raised or
left lowered.
Ending Application Checklist Page
1 Liq: Plan final passes to avoid complete
run-out.
79
2 Suspend application as above. 83
3 NH
3
: Put on your goggles and gloves -
4 NH
3
: Close nurse tank withdrawal valve 70
5 NH
3
: Re-enter cab. Turn MASTER switch
ON
-
6 NH
3
: Resume field application.
Raise flow rate to maximum.
70
7 NH
3
: Continue application until cooler and
flow divider pressures are zero.
-
8 NH
3
: Turn into wind. -
9 NH
3
: Raise applicator and stop. 51
10 NH
3
: Set MASTER switch off. -
11 NH
3
: Wait one minute. -
12 NH
3
: Turn left (wind from right). Stop. -
13 NH
3
: Open all bleed valves. 70
14 NH
3
: Close all line valves. 70
15 NH
3
: Wait one hour. 70
16 Liq: Apply excess fertilizer (leaving some)
to the final field.
79
17 Liq: Refill tank with clean water. 79
18 Liq: Set application rate to maximum. 79
19 Liq: Apply water to final field / flush
system.
79
20 Liq: Close all shut-off valves at
tank/applicator connections.
79
21 NH
3
: Safe and unhitch nurse tank.
Liq: Unhitch nurse tank (if used)
73
79