Great Plains SR5030 Operator Manual - Manual (Page 25)

23
Section 5 Maintenance and Lubrication
4/12/05 SR5030 Split-Row Planter 401-140M-A
Great Plains Mfg., Inc.
Figure 5-12
12355
Meter Drive Chain Routing
Storage
Store planter in a clean, dry place with all tires out of the
sun. Store planter where children do not play. If possible,
store planter inside for longer life.
1. Thoroughly clean planter, hoppers and meters. Re-
move any dirt and debris that can hold moisture and
cause corrosion.
2. Remove finger-pickup meters from hoppers. Disas-
semble the meters and inspect them for wear. Refer to
Finger Pickup Meter, page 26Make any repairs re-
quired at this time. Blow excessive debris from the
meter. Wash the meters with mild soap and water. Dry
meters and spray a light coat of rust inhibitor on
meters. Reassemble and store meters in a dry place.
3. Inspect planter for worn or damaged parts. Make re-
pairs and service during the off season.
4. Use spray paint to cover scratches, chips and worn ar-
eas on the planter to protect the metal.
5. Adjust all drive chains.
6. Lubricate planter at points listed under Lubrication,
page 24. Be sure to lubricate chains to prevent rust-
ing.
7. Place the 1 X 12 closing-wheel handle in the middle
slot to relieve the tension on the closing wheels. Move
T-handle for opener springs to the lightest setting.
8. Cover planter with a tarp if stored outside.