Great Plains TC5319 (S/N A1420X+) Predelivery Manual - Manual (Page 20)

16 TC5109-5323 Great Plains Manufacturing, Inc.
566-224Q 03/06/2014
Install Rear Hitch (optional)
Note: The rear tow hitch will be shipped with big compo-
nents banded together and bolts will be in a box.
Carefully un-band the components.
Refer to Figure 19
71. Attach rear hitch trusses
to rear of hitch arms with
3/4 x 2 1/2 hex bolts , 3/4 lock washers and 3/4 nuts.
Attach middle of rear hitch arms to tubes on center
frame with 3/4 x 4 1/32 x 7 1/2 u-bolts
, 3/4 lock
washers and 3/4 nuts.
72. Attach 56” cross arm to bottom side of rear hitch
arm plates with 5/8 x 3 1/32 x 4 1/2 u-bolts , secure
with 5/8 lock washers and 5/8 nuts.
Note: Do not tighten any bolts until every thing is installed.
Note: The bolt on sleeve assembly with rigid or flex slide
may be fastened using 5/8 x 3 1/32 x 4 1/2 u-bolt ,
secure with 5/8 lock washers and 5/8 nuts.
73. Tighten all bolts to specs, See “Torque Values Chart”
on page 17
Completing Setup
74. If the Turbo-Chisel is equipped with an optional finish-
ing attachment, refer to “Parts Manual” for parts break-
down and layout section of Appendix for proper
placement.
If machine is equipped with a rear attachment, be sure you
install the rear jack stand, see “Parts Manual” Rear Jack Stand,
so machine doesn’t tip backwards when unhooking machine
from tractor.
75. Once the options are installed, fold the Turbo-Chisel to
check for clearance and interferences. Slowly fold
Turbo-Chisel while watching that hoses and wiring har-
nesses do not become pinched or kinked, watching for
interferences.
Note: Double check that all bolts are tightened to specs,
See “Torque Values Chart” on page 17.Consult the
“Operator’s Manual”, for the first time field adjust-
ments before going to the field.
Figure 19
Rear Hitch
42648
1
2
5
3
4
6
6
1
2
3
4
5
6
5