Great Plains YP4425A Material Rate - Manual (Page 46)

42 YP3025A, YP4025A and YP4425A Table of Contents Great Plains Manufacturing, Inc.
401-627B Table of Contents 2014-05-13
14. At the monitor main menu, press the
Control Setup softkey.
15. Select and press a button associated with an
undefined or unused material. For example,
“MATRL 7” could be renamed to “Wheat SRW”.
16. Enter the desired or specified values from the Table
on page 41.
17. Press the softkey to return to the Control Setup
menu. Set up any additional seeds as desired.
18. Press the Channel Setup softkey.xx
19. Select Channel 1.
20. Change the channel to “GRAN SEED CONTROL”
21. When switching from planter control to granular seed
control, the Gear Ratio will default to 1. Reset this
value to 1.9. # Seed Rows will default to 0. Reset to
number of active rows.
22. At the Channel Setup screen, press the
Valve Calibration softkey.
Follow the on-screen instructions to run a valve
calibration.
Note: This is not the same as Spreader Constant
calibration (step 35). Valve Cal MUST BE done
any time the monitor is switched into Granular
Seed Control mode.
23. When the calibration is complete, press the
Channel Setup softkey to return to the
Channel Setup screen.
Figure 25
Material Setup Screen #1
31649c
Figure 26
Material Setup Screen #2
31649d