Great Plains 3PYPA Planters - Manual (Page 13)

Installation Front Page Part Lists Great Plains Manufacturing, Inc. 13
06/16/2011 Front Page Part Lists 401-768M
Case Wheeled Tractors
Case/New Holland
Refer to Figure 26
The Steering Sensor Module
with module master input
harness (gray end plug) connected.
Optional adaptor harness for Case/New Holland wheeled
tractors
is necessary when the tractor wheel angle
signal cannot be obtained from the CANbus on the trac-
tor.
833-544C HARNESS CNH WHEEL ANGLE SEN-
SOR WHEEL TYPE
Refer to Figure 27 and Figure 28
1.
The tractor Wheel Angle Sensor harness plug can
be found on the left side of the tractor positioned just
behind the axle and wheel king pin. It is inside the
plastic wire protector.
• Peel back the wire protector.
• Disconnect the wheel sensor harness
(see Figure 27).
• Plug adaptor harness in where wheel sensor
was disconnected (see Figure 28).
• Reconnect wheel sensor to free end of adaptor
harness .
• Run and secure the wheel angle sensor wire from
the Module Master Harness out of the cab to the
SIGNAL OUTPUT wire on the adaptor harness.
2. Run the module output signal wire from the cab to
the back of the tractor and plug it into the steering
harness connector.
Null4:
Figure 26
Case/NH Wheeled Tractors
Adaptor Harness
31839
16
1
1
16
16
Null4:
Figure 27
Case Tractor
31853
2
2
16
16
Null4:
Figure 28
Install Adaptor Harness
31827
16
16