Operating instructions, General description, Pre-start checklist – Great Plains 1300 13-Foot Operator Manual User Manual
Page 20: Start checklist
175-157M
2014-04-15
16
1300 and 1300F
Great Plains Manufacturing, Inc.
Operating Instructions
This section covers general operating procedures.
It assumes that setup items have been completed.
Experience, machine familiarity and the following
information will lead to efficient operation and good
working habits. Always operate farm machinery with
safety in mind.
General Description
Field operations are controlled by a tractor cab hydraulic
lever. When openers are lowered, a mechanical clutch
engages, and the left end wheel drives the seed meter
shaft.
Seed and fertilizer meters operate at a rate proportional
to ground speed, as set by sprockets and/or rate
handles, based on the rate charts, and calibration.
Seeding depth and furrow coverage are controlled by drill
down pressure and row unit setup.
Pre
-
Start Checklist
High Pressure Fluid Hazard:
Escaping fluid under pressure can penetrate the skin causing
serious injury. Avoid the hazard by relieving pressure before
disconnecting hydraulic lines. Use a piece of paper or
cardboard, NOT BODY PARTS, to check for suspected leaks.
Wear protective gloves and safety glasses or goggles when
working with hydraulic systems. If an accident occurs, seek
immediate medical attention from a physician familiar with
this type of injury.
❑ Lubricate the drill as indicated under Lubrication,
“Maintenance and Lubrication” on page 41.
❑ Check the tires for proper inflation according to
“Tire Inflation Chart” on page 58.
❑ Check for worn or damaged parts and leaks.
Repair or replace before going to the field.
❑ Check all nuts, bolts and screws. Tighten bolts as