Great Plains 4000TM Predelivery Manual - Manual (Page 34)

30 1200-4000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-288Q Table of Contents Index 11/06/2012
Rear Lights 3500-4000
Refer to Figure 33
Note: See layout drawings in Appendix for proper light bracket
placement. If machine is not equipped with a rear at-
tachment the rear light brackets will need to be mounted
to the rear tube of the center frame with 1/2 x 3 1/32 x 6
u-bolts.
116.Remove u-bolts from light brackets. Install the RF/LR
and LF/RR light brackets with the 1/2 x 3 1/32 x 4 u-
bolts , 1/2 lock washers and 1/2 nuts.
117. Tighten all bolts to specs, See “Torque Values Chart” on
page 36.
Install Decals
Refer to Figure 34
Note: The center brace bar decals will need installed in loca-
tions shown. Clean the area on which the decal is to be
placed. Peel backing from decal. Press firmly on sur-
face, being careful not to cause air bubbles under decal.
118.Install two, 838-615C amber decals (one each side).
119.Install one 838-611C hand crushing decal on front of
brace bar (right side).
Refer to Figure 35
120.Install one, 848-829C (Models 1800-3000), 848-972C
(Model 3500) or 858-002C (Model 4000) bypass valve
operating instruction decal
on front of truss (left side).
121.Install one, models 1800-3000, 848-844C fold valve decal
on front tube of center brace bar (left side) with arrow
pointing towards two way fold valve . On models 3500-
4000 mount on top of left, front torque tube , arrow fac-
ing towards two way fold valve on bypass valve.
Figure 33
Rear Lights 3500-4000
42889
2
3
1
1
2
3
Figure 34
Decals
42421
2
1
1
2
Figure 35
Hydraulic Decals
42422
4
3
5 7
6
3
4
6
5
7