Great Plains 4000TM Predelivery Manual - Manual (Page 19)

15 1200-4000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-288Q Table of Contents Index 11/06/2012
Wing & Brace Bar 1800-3000 & 4000
Refer to Figure 19
Note: The wings
will come partially pre-assembled. Models
1800-2400 will be shipped with wings attached in
folded position but will need wing braces attached as
shown. Un-fold wings before attaching wing braces. On
models 3000, place wing frame assemblies
on
stands next to center frame. Model 4000, See “Wing,
Brace Bar & Fold 3500-4000” on page 16 before in-
stalling outside wing.
64. Attach wing brace to front of wing frame with 3/4 x 2
Gr. 5 hex bolts , 3/4 lock washers and 3/4 nuts.
65. Remove wing hinge pins from center frame hinge .
Attach wing frame assemblies to center frame with
the wing hinge pins , 1 1/4 flat washers (rear side of
wing hinge tubes only, do not use on wing brace bar) and
1 top lock nuts.
66. Do not hook up rod end of fold cylinder until system is
purged of air. See “Purging Hydraulic System 3000-
4000” on page 27.
67. Bolt may be tightened to specs, See “Torque Values
Chart” on page 36.
Figure 19
Wing & Brace Bar 1800-3000 & 4000
42390
3
2
1
7
U
D
F
B
L
R
4
5
6 6
3
3
1
3
1
2
4 5
3 5
4 6
7