Great Plains 4000TM Predelivery Manual - Manual (Page 32)

28 1200-4000TM Table of Contents Index Great Plains Manufacturing, Inc.
586-288Q Table of Contents Index 11/06/2012
Depth Stop & Angle Gauge
Refer to Figure 29
Note: See machine layout drawings in Appendix for
proper gang gauge placement for each model.
102.Slide depth stop tube from rear of machine under
left wing stop through square hole on depth control
bracket on center wing brace. Align rear holes over
lever on torque tube, secure with 1/2 x 3 hex bolt
,
1/2 top lock nut.
103.Fasten depth stop assembly on top of depth stop
tube with 1/2 x 2 1/2 hex bolts , 1/2 lock washers
and nuts.
104.Attach angle gauge bracket assembly to front of
center frame with 1/2 x 3 1/32 x 6 u-bolts , 1/2 lock
washers and 1/2 nuts.
105.Attach gauge link to ear on front of center frame
and gauge bracket assembly , secure with 3/8 x 1
1/4 hex bolts and 3/8 top lock nuts.
106.Bolt may be tightened to specs, See “Torque Values
Chart” on page 36.
1
2
3
4
5
6
7
5
8
Figure 29
Depth Stop & Angle Gauge 42414
U
D
F
B
L
R
8
5
6
4
3
1
2
7