Wheatheart Transfer Auger - Manual (Page 29)

W HEATHEART M ANUFACTURING - T RANSFER A UGER 5. O PERATION
8”, 10”, & 13” 5.3. O PERATING P ROCEDURES
IM2 R2 29
5.3. OPERATING PROCEDURES
5.3.1. B
REAK
-I
N
P
ERIOD
Your auger does not require an elaborate break-in. However, following a few
simple tips during the first 1000 bu of operation can add to the reliability and life
of your machine.
If any unusual noises or vibrations are encountered, determine the source, shut
the auger off, lock out the power source, and adjust. If unsure of the problem, or
the procedure to fix it, contact your local Wheatheart dealer.
P RE O PERATION C HECKLIST :
• Read the power source operation manual.
• Inspect motor mounting bolts for tightness.
• Check oil level in the gear box by removing the filler plug. Make sure the
gear box is half full (center cross shaft) and free of foreign objects.
• Inspect all belts for alignment, tightness, and abnormal wear. Adjust or
replace as required.
• Inspect components for damage and abnormal wear. Replace as
required.
• Check that safety decals are installed and legible. Apply new decals if
required.
• Check upper chain drive tension and alignment, apply or adjust grease.
Please refer to “Maintenance Intervals” on page 34 for recommended service
intervals after the break-in period.
5.3.2. O
PERATION
The following items should be checked before operating the machine each time:
• Visually inspect the machine.
• Ensure that all guards are in place, and secure.
WARNING
Hydraulic fluid can cause serious injury if it
penetrates the skin. If it does, see a doctor
immediately.
• Relieve pressure before disconnecting
hydraulic lin.
• Wear proper hand and eye protection and
use wood or cardboard, not hands, when
searching for leaks.