Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD - Manual (Page 48)

5. O PERATION WHEATHEART - GHR & WHR GRAIN AUGERS
5.3. O PERATION P ROCEDURE PTO-SD D RIVE M ODEL
48 30641 R1
• If the problem is plugging, clear as much of the grain as possible using a
piece of wood, wet/dry vac, or other tool before restarting auger. Do not
reach in and use your hands even if the tractor has been locked out.
2. If auger tube is full of grain, do not restart at full speed. Engage PTO at low
rpm, gradually increasing power until normal operating speed is reached.
5.3.4. L
OWERING
& C
OMPLETION
After operation:
1. Clean entire work area.
2. Remove all supports and chocks.
3. Move
auger out of working position and lower fully (see shaded box that
follows for lowering procedure).
4. Move auger to the next work area or to a storage area and then clean out.
5. Clean out auger.
a. Shut off tractor engine and lock out power.
b. Manually clean out grain with a piece of wood, vacuum cleaner, or other
tool. Do not use hands.
c. If auger has been used to transport fertilizer, it should be cleaned out to
prevent corrosion. The easiest way to prevent corrosion is to run a load of
grain through it after transporting fertilizer.
6. Prepare for transport and placement or storage (see appropriate chapters for
more information).
NOTICE
Starting the auger when there is grain blockage will result in
damage.
L OWERING
1. Disconnect PTO driveline from tractor before lowering.
2. Ensure area beneath auger is clear.
3. Turn winch counterclockwise to lower (there will be no clicking sound when
lowering).
4. After lowering, turn handle clockwise until you hear 2 clicks to lock brake.
• Use a firm grip on handle. Do not release unless the ratchet pawl is fully
engaged.
• The winch is designed for manual operation only.
• When lowering, never continue to turn handle counterclockwise if the
cable does not keep moving out under load. This will disengage the
brake mechanism and create an unsafe condition. If this happens, winch
in slack cable and correct problem.
Do not leave auger in raised position when not in use. Auger could drop rapidly
due to a cable break. High winds may also upset auger.