Wheatheart WHR 80/100 x 31-71ft Augers PTO-SD - Manual (Page 36)

3. A SSEMBLY WHEATHEART - GHR & WHR GRAIN AUGERS
3.14. W INCH & L IFTCABLE PTO-SD D RIVE M ODEL
36 30641 R1
Important: Winch handle must be positioned on the left side of the auger (determine left by
standing at the intake end, facing the discharge end).
2. Attach winch to winch mount with three 3/8” washer locknuts.
Important: Winch handle must be positioned on the left side of the auger (determine left by
standing at the intake end, facing the discharge end).
Note: If auger has more than 1 winch mount, use the bracket nearest the intake end.
3. Thread lift cable under and around roller on track shoe, then back to cable
attach rod welded to lower end of track.
Note: On auger equipped with a lower angle-iron track stop, the cable must be
threaded between track stop and auger tube so cable rests on top of the track
stop (See Figure 3.24).
4. Wrap cable 1-1/2 times
around the cable attach rod
and secure with two 1/4”
cable clamps. Position
cable clamps as shown in
Figure 3.24 and 3.25.
Tighten clamps securely.
Note: Make certain cable is properly seated in cable groove before raising auger.
3.14.1. W
INCH
H
ANDLE
This auger may use one of several different winch models. Before installing
handle on the main winch assembly, check the model number stamped on winch
housing and follow the correct set of instructions.
Figure 3.24
Figure 3.23
Figure 3.25
CAUTION
Winch handle assembly must follow the
instructions below. Improper assembly will
result in sudden winch failure causing
damage to equipment and/or personal injury.