ClearOne CHAT 150 User Manual
Page 13
10 Technical Support: 800.283.5936
2. Using the included 6’ RCA cable, connect the CHAT 150 VC Breakout Box to both your video conferencing device
and/or TV/monitor, as shown in the following illustration. The cable has two RCA connectors on one end, and five on
the other end, split into two groups with two and three connectors.
The end with two connectors goes to the VC Breakout Box. The blue connector connects to the Audio In port
(identified by the
icon), and the black connector goes to the Audio Out port (identified by the
icon).
On the other end of the cable, the group with the Red (Right) and White (Left or Mono) connector plugs into the
corresponding audio ports on your TV. This connection allows you to either use the speaker on your CHAT 150 for audio
from the far end, or alternatively you can use the speakers on the TV. See Advanced Settings: Audio Settings in
Chapter 4: Using The CHAT Application for details on using this option.
The group with three connectors goes to your video conferencing device. The Red (Right) and White (Left or Mono)
connectors go to the corresponding Audio Out ports. However, if your video conferencing device does not have left and
right audio out, but only has a single channel (mono), connect the white connector to send a mono audio signal to the
CHAT 150. The black connector is inserted into the Audio In port.
3. Slide the correct power supply clip for your country into the included power supply. The power supply may contain a
plastic shield that must be removed before inserting the clip.
(
(
)
)
(
(
)
)
(
(
)
)
)
(
(
)
)
)
(
(
)
)
(
(
)
)
(
(
)
)
(
(
)
)