ClearOne AP IR Remote - Manual (Page 7)

Using the AP IR Remote
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Once your AP IR Receiver is connected to your Audio Perfect system or GT1524
and the Ready LED is lit, you can start using your AP IR Remote. Please consult
the diagram on page 4 to understand how each button on your remote works. The
remote receiver has a range of 25–40 feet. To operate, point the remote control
toward the receiver and press the buttons.
If you push a button and there is no response from the system, check to ensure
that both the AP device and the receiver are connected at the same baud rate. See
page 5 for instructions on how to program the baud rate.
To Place a Call
1. Press the On (green) button. The In Use LED illumi-
nates.
2. Wait to hear dial tone.
3. Dial telephone number using dial pad. Or, press
Speed Dial and the location of the speed dial number.
To End a Call
• Press the Off (red) button. The In Use LED extin-
guishes.
To Adjust the Volume in the Room
• Press the Volume Up and Volume Down buttons to
raise and lower volume.
To Mute
• Press the Mute On button.
The Mute LED will flash on the receiver when the Mute
function is active. If you have not programmed this func-
tion, the default programming will mute all microphone
inputs on all devices, all units. To customize mute com-
mands, see page 7.
To Turn Off Mute
• Press the Mute Off button.
The Mute LED on the AP IR Receiver will turn off when mute function is off.
11 Programmable Functions 10
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Hook Flash (AP400 and GT1524 Only)
Hook flash sends a momentary interruption in the line seizure, allowing options such
as 3-way calling, call waiting, and call hold. This feature is dependent on the
services offered by your telephone company.
To program hook flash
1. Press and hold the Program button until the LEDs in the receiver flash.
2. Press the Flash button.
3. Press 1 for 50ms or 2 for 500ms.
This information is stored in the AP400 or GT1524 and not in the AP IR Remote.
Hook flash example
To change the hook flash duration from default (500ms) to 50ms, enter:
AP IR Remote Default Settings
The AP IR Remote Control System comes pre-programmed with default settings for
all of the button functions. You can restore the default settings at anytime. Please
note that you will lose all customized programming if you restore the default settings.
To restore default settings
1. Press and hold the Program button until the LEDs in the receiver flash.
2. Press ****.
Restore default settings example
To restore the AP IR Remote default settings, enter:
PROGRAM
1
FLASH
PROGRAM
* * * *
Using the AP IR Remote
OFF ON
1 2 3
4 5 6
7 8 9
0
VOLUME
ABC DEF
GHI JKL MNO
TUV PQRS WXYZ
* #
MUTE
OFF
MUTE
ON
FLASH REDIAL PROGRAM
SPEED
DIAL
CONFERENCE
CALL
Figure 7. Remote control