ClearOne AP IR Remote - Manual (Page 4)

Programmable Functions
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
AP IR transmitter
The AP IR transmitter is used to program and operate the AP systems and GT1524.
The buttons functions are described in Figure 4, below.
5 Introduction 4
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
OFF ON
1 2 3
4 5 6
7 8 9
0
VOLUME
ABC DEF
GHI JKL MNO
TUV PQRS WXYZ
* #
MUTE
OFF
MUTE
ON
FLASH REDIAL PROGRAM
SPEED
DIAL
CONFERENCE
CALL
Mute Off
Press to turn the mute
function off.
Program
Press for two seconds
to enter Program mode.
See page 5.
Speed Dial
Press to dial telephone
numbers that have been
programmed into the
Speed Dial function. See
page 6.
Volume Down
Press to lower the audio
level in the room.
Volume Up
Press to raise the audio
level in the room.
Mute On
Press to mute all
microphones in the room
(default). Can be
programmed to mute specific
microphones in the room.
Flash
Provides a hook flash for
accessing features on your
PBX. Please consult your
PBX owners manual for
specific instructions
regarding your individual
telephone system.
Redial
Press to dial the last
telephone number.
Conference Call
This button does not
perform any functions
at this time.
Numbers
Use these buttons to
dial telephone numbers
and to program
functions.
Telephone On
Press to get a dial tone. Telephone Off
Press to end a call.
Figure 4. AP IR transmitter
Programmable Functions
Your AP IR Remote Control System is designed to operate right out of the box;
however, it is easy to program should you require different specifications. Select
from the options below and follow the instructions for the desired function you want
to customize.
The AP IR Remote does not use flow control. If a connected AP800, AP400, or
GT1524 has flow control enabled, the AP IR Remote will not operate. Disable flow
control on all connected devices.
Baud Rate
In order for you AP IR Remote Control System to operate properly, the baud rate
for the AP IR receiver and for the connected AP or GT1524 unit must be the same.
To program baud rate
1. Press and hold the Program button until the LEDs in the receiver flash.
2. Enter the code for the desired baud rate.
• 22831 = 9,600bps (default)
• 22832 = 19,200bps
• 22833 = 38,400bps
Baud rate example
To change the baud rate of the receiver to 19,200bps, enter:
Telephone Device Type and ID
The default dial command begins with ** which dials any AP telephone device. If
more than one telephone device (AP400 or AP10) is connected to the system, you
need to program the AP IR Remote with the device type and ID number of the unit
it will use for dialing and answering calls.
If there is only one telephone device in your network, or if you are using a sin-
gle unit, you do not need to program the AP IR Remote with the device type and
ID—the default programming will work.
The GT1524 is a stand-alone unit which has no device ID. If you are using this unit,
you do not need to program the telephone device type and ID.
✍
PROGRAM
2 2 8 3 2
✍