ClearOne Converge USB - Manual (Page 10)

CONVERGE USB INTERFACE
8
CONNECTING THE CONVERGE USB UNIT
Connect the CONVERGE USB units to the CONVERGE Pro/SR stack via
the E-bus connections using CAT5/CAT6-24AWG solid conductor RJ45
cables. Power to the CONVERGE USB is supplied by the standard 12V
DC power adapter supplied with the unit.
E-bus LINK IN from Stack
E-bus LINK OUT
(Not required if unit is at end of stack)
USB Connection to
PC/Laptop
12V DC
Power
Input
Terminal Block for
Channel Selection
Mounting
The CONVERGE USB Interface can be conveniently mounted under
the table of a conference room. Place screws through the tabs on the
sides of the unit into the underside of the table. (Screws not provided.)
Pass the USB cable though to the top for use with customer computer
equipment, and route the Link In, Link Out (if needed) and power cables
to their connections.