ClearOne VIEW Pro - E120 Manual - Manual (Page 34)

30 t
EChnICal
s
uPPort
: 800.283.5936
IR LEARNING AND CONTROL
The accessory kits for the IR Emitter and IR Receiver allow the use of these devices with the VIEW
Pro products. For example, an IR Emitter can be placed over the integrated IR Receiver of a display
so signals from the VIEW Pro can be used to control the display. An IR Receiver unit can be used to
receive and relay IR commands to a device placed out of the line of sight of the IR control device.
The VIEW Pro IR tools and IR learning are used in the same manner as the VIEW Legacy products.
Refer to Chapter 7 for the IR Tools section, first section (7-2) explains IR Learning in detail.
3.5mm IR Input
IR Learning
3.5mm IR
Output for
Source Display
or 3rd-Party
Control
IR Receiver
(Self adhesive)
Sensor
direction
Transmit
direction
IR Emitter
(Self adhesive)
FIRMWARE UPGRADING
VIEW Pro The devices can update their firmware in the same manner as the VIEW Legacy devices.
Refer to the Dealer Setup Manual, Chapter 3, Section 2 (3-2) for “Creating and Saving Projects,”
which explains the Firmware Update process in detail.