OSRAM SYLVANIA Chain X2 LED - Manual

Chain X2 LED Lighting System
INSTALLATION GUIDE
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE PERFORMING INSTALLATION OF THE POWER
SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all applicable Federal, State, and local
electric codes as well as the specific Underwriters Laboratories (UL) safety standards for the installation, location and application may cause serious
personal injury, death, property damage and/or product malfunction.
These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may vary depending on the application.
Licensed electricians should provide all installation services for connection for both primary and secondary (input/output) of the power supplies.
Note: For sign retrofits, Chain X2 modules and associated 12V power supplies must only be installed in UL Listed Signs.
1.0 Prepare for Installation
1.1 Tools Required:
- Wire stripper/cutter
-
Screwdriver
-
Measuring tape
1.2 Supplies Required:
-
PLTC Cable
- Wire nuts
-
#8 hex/pan head type screws or rivets
1.3 Carefully remove existing neon or fluorescent tubes, HID or incandescent light sources and power
supplies and/or ballasts if necessary.
1.3.1 Make sure power is turned off.
1.3.2 Remove all existing screws, sockets and wiring.
1.3.3 Dispose of all old sign components in the proper manner.
1.3.4 Clean the inside of the sign ensuring it is free of dirt.
2.0 Mechanical Installation
2.1 Measure the appropriate amount of product for the length of the application and cut. Cuts can be made
between any two modules.
www.sylvania.com/LED
LED297