OSRAM SYLVANIA BoxLED Plus DS BX12BA-W4F - Manual

LED340
BoxLED
®
Plus DS (Double Side)
BX12BA-W4F
Signage Lighting System
INSTALLATION GUIDE
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE
PERFORMING INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all
applicable Federal, State, and local electric codes as well as the specific Underwriters Laboratories (UL) safety
standards for the installation, location and application may cause serious personal injury, death, property damage
and/or product malfunction.
These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may
vary depending on the application. Licensed electricians should provide all installation services for connection for
both primary and secondary (input/output) of the power supplies.
1.0 PREPARE FOR INSTALLATION
1.1 Tools Required:
- Wire stripper/cutter
- Screwdriver
- Measuring tape
1.2 Supplies Required:
- PLTC cable
- Wire nuts/connectors
- #8 screws or rivets
- Accessory Mounting Track and Brackets
1.3 Carefully remove existing neon or fluorescent tubes, HID or incandescent light sources and power
supplies and/or ballasts if necessary.
1.3.1 Make sure power is turned off.
a. Where applicable, determine if a disconnect switch needs to be installed (may be
integral with existing power supply/transformer).
1.3.2 Remove all existing screws, sockets and wiring.
1.3.3 Dispose of all old sign components in the proper manner.
1.3.4 Repair and seal any unused openings in the sign enclosure. Openings gre ater than ½”
diameter require a metal patch secured by screws or rivets and caulked with non-
hardening caulk. Smaller openings may be sealed with non-hardening caulk.
1.3.5 Clean the inside of the sign to make sure it is free of dirt.
www.sylvania.com/SIGNAGE