OSRAM SYLVANIA ProPoint Outdoor Luminaire Small Cobrahead User Manual
Propoint, Outdoor luminaire small cobrahead

ProPoint
TM
Outdoor Luminaire Small Cobrahead
(SC)
Installation Guide
Risk of fire or electrical shock. Install this
module only in the luminaires that have the
construction features and dimensions shown in
the photographs and/or drawings
Do not make or alter any open holes in an
enclosure or wiring or electrical components
during modules installation
To ensure personal safety, proper grounding is
required
Light engine module installation requires
knowledge of luminaire electrical systems. If not
qualified, do not attempt installation. Contact a
qualified electrician
To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other
sharp objects
Cobrahead Fixture available in 55, 80,
100 and 120 Watts, mounts easily on a
1 ¼” NPS or 2” NPS arm
www.sylvania.com
Safety Warnings:
Luminaire Installation:
Open the luminaire by pulling the trigger latch toward the nose of the fixture.
Swing the lower housing (door) away from the upper housing. Disconnect
wiring harness plug. When the lower housing is opened to 135 degree, the
lower housing can be removed from its hinges for easier installation of
upper housing.
Determine the size of the mast arm. This luminaire is designed
to optimally accommodate a 1-1/4”-2” mast arm. Tighten
mounting bolts 10-15 ft-lbs
.
Trigger Latch
SC Upper Housing
PEC Receptacle
Hinge
SC Lower Housing (door)
Lens
/ Reflector
Mast Arm
Fitter Clamp
Fitter Bolt
Leveling Steps
SC Upper Housing with Lower Removed
Loosen the two fitter bolts in the upper housing. Lift the upper
housing into position in front of the mast arm so that the mast
arm enters opening at the rear of the housing and extends into
the fixture between the fitter clap and the luminaire leveling
steps. Using the cast leveling steps, adjust the luminaire to the
desired mounting angle. Fully tighten fitter clamp bolts (10-15 ft-
lbs).
Mast Arm Opening
LED178