Unitec Portal Installation Manual - Manual (Page 22)

P O R T A L T I
Portal Installation Manual Rev C 18
Figure 13. Portal Interior
3.4 Connecting Power
The Portal TI uses an IEC-320-C13 male power inlet to supply the unit with power.
This inlet can be found on the back wall on the right-hand side of the Portal TI case.
1. Locate main power wires. There will be three 16 AWG (or greater)
environmentally rated black, white, and green colored wires.
2. Route the main power wires to the Portal’s input power connector and
remove excess wire length, leaving sufficient length to reach the AC power
inlet.
3. Remove the 3-pronged AC connector from the AC power inlet (supplied with
the Portal)
4. Disassemble the outer housing.
Document #: PTL1001