Tweco 4-3054 - Manual (Page 4)

Manual 0-4964 Rev AA.01
February 5, 2007 4
4. Locate fuses at F14 and F15 shown below.
J13
Art # A-07652
Fuses F14 and F15 are 250V and .0250A
F14 F15
New Fuse
Rating Label
NOTE
Check the values of these fuses. If the fuses are
the same as those provided in this kit do not
replace them and go to step 7.
5. If the fuses at F14 and F15 are not 250VAC .0250A,
replace them with two of the four provided in this kit.
The other two are extra and should be saved for pos-
sible future use along with the two being removed. Do
not use the fuses in this kit in any other location on
this PCB.
6. Locate the new Fuse Rating Label supplied in this kit
and where it is to be applied shown above. Before ap-
plying the new Fuse Rating Label on the PCB ,clean
the surface using a clean cloth. If cleaning solution
is needed it must be approved for use on and around
electrical components. Once the surface is clean and
dry, apply the label.
7. Reconnect the harness plug to J13 and replace the
cover with the ground wire attached.