Tweco 9-8587 - Manual (Page 10)

Manual 0-5185 10
Figure 26: Cord Grip Screws
End of Procedure
15. It is advisable to test the CE power circuit to the Cutmaster True Power Supply after this procedure is completed.
Refer to the owners manual for the specific version for instruction.
Removal for Voltage Changeover
WARNING
Disconnect the Mains Power to the power supply before attempting to remove the contactor enclosure
cover!
16. Removal of the contactor box cover is done by unlatching the outboard side three latches and pressing against
the inboard side with a screwdriver. Completely loosen one latched side before moving to the other.
Figure 27: Contactor Enclosure removal
NOTE
Every effort has been made to provide complete and accurate information in this manual. However,
the publisher does not assume and hereby disclaims any liability to any party for any loss or damage
caused by errors or omissions in this Manual, whether such errors result from negligence, accident, or
any other cause.