Tweco 82 CutMaster User Manual
Operating manual, Cutmaster, Plasma cutting system
Table of contents
Document Outline
- SECTION 1:GENERAL INFORMATION
- SECTION 2 SYSTEM:INTRODUCTION
- SECTION 2 TORCH:INTRODUCTION
- SECTION 3 SYSTEM: INSTALLATION
- SECTION 3 TORCH: INSTALLATION
- SECTION 4 SYSTEM: OPERATION
- SECTION 4 TORCH:OPERATION
- 4T.01 Torch Parts Selection
- 4T.02 Cut Quality
- 4T.03 General Cutting Information
- 4T.04 Hand Torch Operation
- 4T.05 Gouging
- 4T.06 Mechanized Torch Operation
- 4T.07 Parts Selection for Manual and Mechanized Torch Cutting
- 4T.08 Recommended Cutting Speeds for Mechanized Torch With Exposed Tip
- 4T.09 Recommended Cutting Speeds for Mechanized Torch With Shielded Tip
- PATENT INFORMATION
- SECTION 5 SYSTEM:SERVICE
- SECTION 5 TORCH:SERVICE
- SECTION 6:PARTS LISTS
- 6.01 Introduction
- 6.02 Ordering Information
- 6.03 Power Supply Replacement
- 6.04 Replacement Power Supply Parts
- 6.05 Options and Accessories
- 6.06 Replacement Parts for Hand Torch
- 6.07 Replacement Parts - for Machine Torches with Unshielded Leads
- 6.08 Replacement Shielded Machine Torch Leads Assemblies
- 6.09 Torch Consumable Parts (SL60)
- 6.10 Torch Consumable Parts (SL100)
- APPENDIX 1: SEQUENCE OF OPERATION(BLOCK DIAGRAM)
- APPENDIX 2: DATA TAG INFORMATION
- APPENDIX 3: TORCH PIN - OUT DIAGRAMS
- APPENDIX 4: TORCH CONNECTION DIAGRAMS
- APPENDIX 5: SYSTEM SCHEMATIC, 208/460V UNITS
- APPENDIX 6: SYSTEM SCHEMATIC, 600V UNITS
- APPENDIX 7: Publication History