Tweco PAK 44G User Manual

Pak 44g

Text mode
Original mode

Operating Manual

August 25, 1998

PAK 44G

PLASMA GOUGING SYSTEM

Manual No. 0-2686

Table of contents

Document Outline

SECTION 1: GENERAL INFORMATION
1.01 Notes, Cautions and Warnings
1.02 Important Safety Precautions
1.03 Publications
1.04 Note, Attention et Avertissement
1.05 Precautions De Securite Importantes
1.06 Documents De Reference
1.07 Declaration of Conformity
1.08 Statement of Warranty
SECTION 2: INTRODUCTION & DESCRIPTION
2.01 Scope of Manual
2.02 General Description
2.03 Specifications & Design Features
2.04 Power Supply Options and Accessories
SECTION 3: INSTALLATION PROCEDURES
3.01 Introduction
3.02 Site Selection
3.03 Unpacking
3.04 Removing Skid
3.05 Installation Of Optional Running Gear
3.06 Input Power Connections
3.07 Primary Voltage Selection
3.08 Primary Power Cable Connections
3.09 Work Cable And Ground Connections
3.10 Plasma and Secondary Gas Connections
3.11 Connecting Torch Leads
3.12 Filling Power Supply Coolant
3.13 Initial Start-Up Of System
SECTION 4: OPERATION
4.01 Introduction
4.02 Functional Overview
4.03 Operating Control Descriptions
4.04 Getting Started
4.05 Gouging Operation
SECTION 5: CUSTOMER/OPERATOR SERVICE
5.01 Introduction
5.02 General Power Supply Maintenance
5.03 Common Operating Faults
5.04 Troubleshooting Guide
5.05 Gas Pressure Regulators
SECTION 6: PARTS LISTS
6.01 Introduction
6.02 Ordering Information
6.03 Power Supply Remote Aera Spare Parts Kit
6.04 Power Supply Options and Accessories
APPENDIX I: INPUT WIRING REQUIREMENTS
APPENDIX II: SEQUENCE OF OPERATION BLOCK DIAGRAM
APPENDIX III: TIMING CHART
APPENDIX IV: SYSTEM BLOCK DIAGRAM
APPENDIX V: RECOMMENDED ROUTINE MAINTENANCE SCHEDULE FOR WATER COOLED PLASMA CUTTING SYSTEMS
APPENDIX VI: SYSTEM SCHEMATIC