Tweco C-100A CutSkill - Manual (Page 19)

Manual 0-4686 3-3 Installation
3.03 Compressed Air Connection
• An air compressor is required and should be con-
nected by an air hose to the air regulator on the
rear panel of the power supply .
• Air flow should be 400 scfh / 6.6 scfm (188.7 lpm)
minimum.
Input Power
Cable
Connect
Air Here
Art # A-04489
3.04 Torch
• Make sure that the torch cable and torch switch
terminals are connected through the front panel.
• Make sure the Work Cable is connected properly
through the front panel and the clamp to clean
work surface.
• Before activating, turn torch away from yourself
and others.
DANGER
Do not cut in humid or wet surroundings.
• Before you maintain or replace torch parts, wait
for the post flow air cycle (approximately 10 sec-
onds), to stop, then turn the machine off.
• Always use original manufacturers parts. The use
of aftermarket parts could result in lower parts
life and in unsatisfactory cutting results. Any
warranty claims would be waived.
• Recycle worn parts according to local require-
ments.
NOTE
Repairs must be done by skilled and qualified
personnel only.