Tweco 35A CutSkill - Manual (Page 19)

cutskill 35A
Manual 0-5104 4-1 OPERATION
SECTION 4 SYSTEM:
OPERATION
4.01 Control Panel
RUN
SET
CURRENT (A)
15
25
35
READY AIR OVERHEAT POWER
Cutting Current Control
Work Lead Connection
Power On Indicator
Torch Connection
Run/Set Switch
Over Heat Indicator
Air Indicator
DC Indicator
Art # A-09179
Adjustment knob
of compressed
air Pressure
Power switch
Compressed air
pressure meter
Power cable
input
Air filter
Compressed
air input
Art # A-09409
The Front Panel The Rear Panel
1. ON / OFF Switch (Power Switch)
Controls input power to the power supply. I is ON, O is OFF.
2. RUN / SET Switch
RUN (up) position is for general torch operation. SET (down) position is for setting gas pressure and
purging lines.
3. (A) Output Current Control
Sets the desired output current. If the overload protection (fuse or circuit breaker) on the input power
circuit opens frequently, either reduce cutting output, reduce the cutting time, or connect the unit to more
adequate input power. Refer to Section 2 for input power requirements.
4. Power ON Indicator (AC Indicator)
Steady light indicates power supply is ready for operation.
5. OVERHEAT Indicator (TEMP Indicator)
Indicator is normally OFF. Indicator is ON when internal temperature exceeds normal limits. Allow the unit
to run with the fan on until the temp indicator turns off.
6. AIR Indicator
AIR light should be ON when there is insufficient gas pressure (below 50 psi).
7. READY (DC Indicator)
Indicator is ON when DC output circuit is active.
8. Parts - in - place ( PIP)