Trail Master Suspension TM407N FORD F-150 4WD 6 SUSPENSION LIFT KIT - Manual (Page 5)

5
TM407N
Revised
6.14.13
d. Remove brake rotor from spindle.
e. Remove dust cap on center of spindle and
remove axle nut.
f. Unbolt ABS sensor and tie up out of the
way.
g. Loosen nut securing tie rod end to spindle.
Use tie rod end puller to dislodge tie-rod end
from spindle and remove.
h. Loosen but do not remove nut securing up-
per ball joint to spindle. Use ball joint puller to
dislodge upper ball joint from spindle.
i. Loosen but do not remove nut securing
lower ball joint to spindle. Use ball joint puller
to dislodge lower ball joint from spindle.
Sway Bar
Clamp
Axle nut
ABS Sensor
Upper
Ball Joint
Tie Rod
End
Lower
Ball Joint