Trail Master Suspension TM407N FORD F-150 4WD 6 SUSPENSION LIFT KIT - Manual (Page 11)

11
TM407N
Revised
6.14.13
f. Check clearance between frame and differ-
ential inside pocket and around area of
frame cut. Clearance additional material if
needed to prevent rubbing.
6. Install kit front crossmember into OE
lower control arm pivot pockets and secure
using lower control arm pivot hardware. Do
not tighten at this time.
7. Install four kit 7/16” x 1 1/2” bolts &
hardware on passenger side of rear cross-
member above mounting tabs for brace just
installed. Holes are on both front and back of
frame/crossmember. The holes on the rear
of the crossmember will match with the pas-
senger differential bracket. Do not torque at
this time.
Check Clearance all
around this area
NOTE
Minor trimming may be needed on OE rack and pinion
mount to fit crossmember into place.
Driver Side
Rack Mount
Trimming may be
necessary here
Rearward facing
bolts
Kit Front Crossmember
82-TM241003