beautypg.com

Data request, Data transfers, 2 data transfers – Compaq W4000 User Manual

Page 66

background image

Chapter 4 System Support

4.3.1.1

D

The differences in rates will be discussed in the next

ction describing data transfers. Note also that sideband addressing is limited to 48 bits (address

its 48-63 are assumed zero). The MCH component supports both SBA and AD addressing , but

er the 66-MHz CLK signal is used to qualify the control and data signals.

is synchronous with one CLK cycle so it takes two CLK cycles for a

inimum 8-byte transfer (Figure 4-5 shows two 8-byte transfers). The GNT- and TRDY- signals

ers

Figure 4-5. AGP 1X Data Transfer (Peak Transfer Rate: 266 MB/s)

Data

Request


Requesting data is accomplished in one of two ways; either multiplexed addressing (using the A
lines for addressing/data) or demultiplexed (“sideband”) addressing (using the SBA lines for
addressing only and the AD lines for data only). Even though there are only eight SBA lines (as
opposed to the 32 AD lines) sideband addressing maximizes efficiency and throughput by
allowing the AD lines to be exclusively used for data transfers. Sideband addressing occurs at the
same rate (1X, 2X, or 4X) as data transfers.
se
b
the method and rate is sel

d by the

P grap

adapte

4.3.1.2 Data

Transfers

ata transfers use the AD lines and occur as the result of data requests described previously. Each

ans

resulting from a request involves at least eight bytes, requiring the 32 AD lines to

andle at least two transfers per request. The 82845 MCH supports three transfer rates: 1X, 2X,

nd

gardless of the rate used, the speed of the bus clock is constant at 66 MHz. The

llowing subsections describe how the use of additional strobe signals makes possible higher

an

es.

ecte

AG

hics

r.


D
tr

action

h
a 4X. Re
fo
tr sfer rat

AGP 1X Transfers


During a AGP 1X transf
Each 4-byte data transfer
m
retain their traditional PCI functions. The ST0..3 signals are used for priority encoding, with
“000” for low priority and “001” indicating high priority. The signal level for AGP 1X transf
may be 3.3 or 1.5 VDC.


TRDY

-

GNT

-

CLK

D1A

D2A

D2B

D1B

00x

xxx

xxx

xxx

xxx

xxx

ST0..2

AD

T1 T2 T3 T4 T5 T6 T7












Compaq Evo and Workstation Personal Computers

Featuring the Intel Pentium 4 Processor

Second Edition – January 2003

4-12