beautypg.com

Temperature status, Drive fault prediction, Pnp support – Compaq W4000 User Manual

Page 152: 3 temperature status, 4 drive fault prediction, 6 pnp support

background image

Technical Reference Guide


7.5.3 TEMPERATURE STATUS


The BIOS includes a function (INT15, AX=E816h) to retrieve the status of a system’s interior
temperature. This function allows an application to check whether the temperature situation is at a
Normal, Caution, or Critical condition.

7.5.4 DRIVE FAULT PREDICTION


The Compaq BIOS directly supports Drive Fault Prediction for IDE-type hard drives. This feature
is provided through two Client Management BIOS calls. Function INT 15, AX=E817h is used to
retrieve a 512-byte block of drive attribute data while the INT 15, AX=E81Bh is used to retrieve
the drive’s warranty threshold data. If data is returned indicating possible failure then the
following message is displayed:

“1720-SMART Hard Drive detects imminent failure”

7.6 PNP

SUPPORT


The BIOS includes Plug ’n Play (PnP) support for PnP version 1.0A. Table 7-5 lists the PnP
functions supported.
Table 7-5. PnP BIOS Functions

Table 7-5.

PnP BIOS Functions

Function Register
00h

Get number of system device nodes

01h

Get system device node

02h

Set system device node

03h Get

event

04h Send

message

50h

Get SMBIOS Structure Information

51h

Get Specific SMBIOS Structure

The BIOS call INT 15, AX=E841h, BH=01h can be used by an application to retrieve the default
settings of PnP devices for the user. The application should use the following steps for the display
function:

1. Call PnP function 01(get System Device Node) for each devnode with bit 1 of the control flag

set (get static configuration) and save the results.

2. Call INT 15, AX=E841h, BH=01h.
3. Call PnP “Get Static Configuration” for each devnode and display the defaults.
4. If the user chooses to save the configuration, no further action is required. The system board

devices will be configured at the next boot. If the user wants to abandon the changes, then the
application must call PnP function 02 (Set System Device Node) for each devnode (with bit 1
of the control flag set for static configuration) with the results from the calls made prior to
invoking this function.

Compaq Evo and Workstation Personal Computers

Featuring the Intel Pentium 4 Processor

Second Edition - January 2003

7-15