Revel Voice 2 - Manual (Page 20)

Ultima Voice2
Owner’s Manual
20
BI-WIRED CONNECTIONS
Bi-wired connections are made between both pairs of the Voice2
input terminals and one power amplifier output channel as
shown in Figure 12.
To make bi-wired connections:
1. Remove the jumper straps identified in Figure 3.
2. Connect one pair of loudspeaker wires to the high-frequency
pair of Voice2 input terminals. Then connect the same pair
of loudspeaker wires to the desired power amplifier output
channel.
3. Connect another pair of loudspeaker wires to the low
frequency pair of Voice2 input terminals. Then connect the
pair of loudspeakers to the same power amplifier output
channel that was selected in Step 2.
4. Make sure that all terminals are firmly hand-tightened.
Figure 12: Bi-Wired Connections
OUTPUT
POWER
AMPLIFIER
Voice2