Revel LFO User Manual
Page 22
22
LFO Programming Software
User Guide
5. When you are satisfi ed with the improvement created by EQ1 fi lter, repeat steps 3 – 4 with EQ2 fi lter to reduce the next peak in response. Note that the
parameters of the two fi lters may interact, in which case you will have to adjust each more than once to get the area to match the Target Response curve.
Area Improved
by EQ2 Filter
EQ2 Filter
6. Concentrate on the region between 20Hz and 200Hz. Try to make this region correspond to the Target Response curve as closely as is practical.
Once you have reduced all the large response peaks the Measured Response curve should be very close to the Target Response Curve. Note that eight
EQ fi lters were required to achieve the results shown below.