Gossen Digiflash - Manual (Page 6)

GOSSEN Foto- und Lichtmeßtechnik 6
2 Functions of the Digiflash
Press the function button for selecting the
individual functions of the Digiflash.
Each time the button is pushed, the next
function will be activated.
The display panel will show the functions in
the following sequence:
• Ambient light
• Flash light
• Timer
• Watch
• Alarm clock
• Temperature
The next function will only be activated after
the Function button has been released.
When the Function button is kept pressed
down for more than two seconds, the
settings of that function are displayed and
can be adjusted as desired.
2.1 Setting the film speed
– Select the function "Exposure ambient
light" and hold down the function button
until the OK-signal sounds. The display
will show ISO, blinking.
– Use the measuring key M to select the
desired film speed.
When holding the key M pressed down,
the film speed will automatically be
increased. When getting close to the
desired ISO value, release the key M
and set the desired film speed by pushing
the key in individual steps.
Each time you push the key, the film
speed is increased by a 1/3 stop.