Gossen Digiflash - Manual (Page 11)

GOSSEN Foto- und Lichtmeßtechnik 11
2.6 Setting correction values
In order to deliberately change the
exposure of your photos, you may adjust
the factory calibration.
– Remove the battery from the Digiflash
and press one of the buttons (battery
memory will be deactivated). Put the bat-
tery back in the compartment. The meter
will then make the self-test.
– During this test, keep the measuring key
and also the function button pressed
down until the accoustic signal sounds.
Release the key to enter the
CORRECTION function.
Use the measuring key M to enter or
change the correction value.
Press the function button again and hold it
down until the OK signal sounds to return
the meter to the normal measuring func-
tions.
The EV in the display will blink to remind
you that the standard factory calibration has
been changed. Input of the correction in
1/3-stops in the range of ± 3 EV.
For cancelling the correction value, remove
the battery from the compartment and then
put it back again.
In case of over-exposure a positive
correction, in case of under-exposure
a negative correction value should be set.