Gossen Digiflash - Manual (Page 12)

GOSSEN Foto- und Lichtmeßtechnik 12
2.7 Function TIMER
A timer function is provided in the Digiflash,
useful for long exposure or other timings
ranging from one second to thirty minutes.
– Use the function button to select the
function TIMER and hold it down until the
OK-signal sounds. The display shows the
last value used. The read-out will show
the "minutes" and will flash to allow the
countdown timer to be adjusted.
– Use the key M to enter the desired time
in minutes.
– Confirm by pushing the function button.
The read-out "seconds" in the display
will flash.
– Enter the "seconds" of the desired length
of time. Confirm by pressing and holding
the function button until the OK-signal will
sound. The timer will now be in the Start/
Stop function.
– Push the key M to start the timer.
The display will show the remaining time
of the count-down. In addition to that,
during the last 10 seconds of the count-
down, interrupted signals can be heard.
At the end of the set time, a continued
signal will sound.