GBC Stl1000 - Manual (Page 8)

7
2. About this Manual REV. 1
2.1
General
This manual is intended as a training and reference document for persons
responsible for installation, service and maintenance of the STL-1000 binder. It is
assumed the reader has basic mechanical and electrical troubleshooting abilities.
This Service Manual, revision ( A ), covers 220 Volt, 3 Phase, 60 Hz STL-1000,
version _1 system.
2.2 Document Control
It is intended that future revisions of this document will be published, please refer
to the revision number on the top of this page to determine the most recent.
2.3 Problem Solving
The path for solving problems with the STL-1000 should proceed in the following
sequence:
1) Find the description of the problem in the table in section 16
2) Evaluate the list of possible causes for the probable one.
3) Proceed to the referenced section (see 4 ) for further diagnosis. Part
replacement instructions (section 18 or 19) or adjustment instructions
(section 6 thru 14 ).
4) If problem is not properly described in the problem column of the
troubleshooting tables of section 16, reread the Theory of Operation
(section 4 ) for insight.
5) If the problem is unsolved call for support with a clear description of the
problem and the results of any unsuccessful solution you have tried.
6) Fill out and Fax the Problem Report Form (section 20 ) after solving
the problem. A strong feedback loop from service personnel is the best
way to improve the design and manufacturing of our products.