GBC Stl1000 - Manual (Page 34)

33
Feed sprocket not
turning. Worm gear clutch pad. Needs
adjustment or clutch pads need
cleaning. Remove collar, spring, pressure
collar, key and worm gear.
Clean all parts with alcohol and
reassemble. Adjust tension
spring to full compression.
Lockout pawl too low. With the air on, adjust height of
lockout pawl and adjust with
height adjustment nut to just
clear lockout gear.
Scrap paper tearing. Scrap paper take up spool. Adjust tension spring behind
panel in line with paper take up
spool. Adjust to have slight
pressure.
Scrap paper not being
spooled. Scrap paper take up spool. Adjust tension spring behind
panel in line with paper take up
spool. Adjust to have slight
pressure.
Improper number of
loops.
Air pressure. Make sure a constant air supply
is maintained at 100
PSI.
Make sure the air regulator on
the STL-1000 is set at 80 psi.
Water separator Empty water separator.
Airline oiler Check airline oiler.
Locking pawl. Check height of locking pawl.
Should just clear the locking
gear.
PROBLEM PROBABLE CAUSE SOLUTION