GBC Stl1000 - Manual (Page 35)

34
Improper number of
loops.
(continued)
Locking gear. Check screws in locking gear for
tightness.
Counting gear. Loosen setscrew on counting
gear and slightly advance
clockwise and test. Repeat until
proper count has been achieved.
NOTE: Disregard first element
after each adjustment
Counting prox sensor. Rotate counting gear and check
for flashing light on the PLC.
Inside the control box. Check
x4 for 2:1 and x10 for 3:1. If
not flashing, prox switch should
be replaced.
Cut length’s tails
uneven. Locking pawl. Disconnect air. With wire in
machine, seat locking pawl into
lockout gear. Check position of
wire in relation to the cutting
block to cut in the center of the
wide leg of the element. If
adjustment is needed, loosen
screw on the side of locking
pawl. Push pawl into locking
gear and rotate until ideal
position has been acquired.
Tighten screw. NOTE: Screw
can be accessed through side
plate.
PROBLEM PROBABLE CAUSE SOLUTION