GBC Stl1000 - Manual (Page 20)

19
SPOOL AND SUPPLY CHUTE LOADING THE SPOOL
(CONTINUED)
4. Lay the wire inside the storage chute and thread the scrap paper between both drive rollers and
wind it up on the scrap take-up spool in a counter-clockwise direction (See Figure 6-3).
Notes:
1. The scrap paper should be wound taunt to prevent it from breaking when the spool drive starts up.
2. The storage chute has a sensor at the bottom to control the spool drive. The sensor will start and
stop the spool drive on demand to replenish the supply of wire to the storage chute.