ExpoImaging ExpoDisc: Canon Custom WB - Manual (Page 3)

Copyright, 2012 ExpoImaging, Inc.
“Canon” and the Canon camera models listed are Trademarks of Canon, Inc.
Canon 6D/70D
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the “P”, “S” or “A”
modes or set the correct manual exposure in “M” mode.
3. Aim the camera towards the light illuminating the subject and press the
shutter release button.
4. Push the ʻMENUʼ button.
5. Under the third menu option scroll down to ʻCustom White Balanceʼ, then
push the ʻSetʼ button in the center of the thumb dial. The custom white
balance selection screen will appear.
6. Select the image that was captured in Step 3, then press the ʻSetʼ button.
7. The dialog screen will appear. Select ʻOKʼ and the data will be imported.
When the menu reappears, press the ʻMENUʼ button to exit the menu.
8. Push the ʻMENUʼ button again to go back into the menu. Under the third
menu option screen select ʻWhite Balanceʼ then press the ʻSetʼ button.
9. Select the custom white balance icon ( ), then press the ʻSetʼ button.
10. Exit the menu, remove the ExpoDisc, return camera to Auto Focus if desired,
and start shooting.
Canon 7D/10D/20D/30D/40D/50D/D60
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the “P”, “S” or “A”
modes or set the correct manual exposure in “M” mode.
3. Aim the camera towards the light illuminating the subject and press the
shutter release button.
4. Push the ʻMENUʼ button to access the menus on the LCD panel.
5. Scroll down to ʻCUSTOM WBʼ in the menu using the thumb dial, then push the
ʻSETʼ button in the center of the thumb dial.
6. Push the ʻSETʼ button again to select the ExpoDisc ʻgray frameʼ just taken. A
reminder message will appear if the camera is not in Custom WB mode.
7. Push the ʻMENUʼ button, or press the shutter halfway to exit the menu.
8. Push and hold the ʻAF-WBʼ button on top of the camera while rotating thumb
dial to select the custom WB icon ( ) in the control panel.
9. Remove the ExpoDisc, return camera to Auto Focus if desired, and start
shooting.