E-flite ElectraJet EP w/ESC & Delta Mix User Manual

Page 6

Text mode
Original mode

Step 14. Remove the backing of the servo tape on the servos.

Step 15. Mount the servos and cables into each of the recesses
in the wings.

Step 16. Insert the Z-bent rod into each control horn of the
ailerons in the wing.

Step 17. Insert the other end of the Z-bent rod into the pushrod
connector. It will be helpful to use small pieces of masking tape to
hold the ailerons at the 0-degree deflection (centered on airfoil of
wing) while the control rods are being attached to the servo arms.

Step 18. With the servo arm centered and ailerons at neutral
(0 degrees deflection up or down), tighten the pushrod
connectors with the hex driver provided.