E-flite ElectraJet EP w/ESC & Delta Mix - Manual (Page 4)

4
Step 1. Use a sanding block with fine sandpaper (preferably
400 grit) to remove the flashing from the areas that glue will be
applied on all foam parts. (Please read ahead to find out where
glue will be applied.)
Step 2. Trial fit the wings (both the left and right panel) onto the
fuselage. When you are satisfied with the fit, mix an adequate
amount of 12-minute epoxy and apply the epoxy to the wing
joiner slots (located on the fuselage) onto the main wings.
Step 3. Position the wing panels onto the fuselage and use
masking tape to hold the wing joints together while the epoxy
cures. Wipe off any excess epoxy using rubbing alcohol and a
paper towel. Make sure that the wing panels are perpendicular to
the fuselage. Please note that the masking tape may alter the fin-
ish slightly. Allow the epoxy to cure completely.
Step 4. Trial fit the hinges that will be placed into the wing for
the Elevons. Mix an adequate amount of 12-minute epoxy. Apply
to one side of the hinges on the horizontal wing. Use very small
amounts of epoxy when installing the hinges. If epoxy gets into
the hinge points, clean off the epoxy using rubbing alcohol.
Step 5. Apply small amounts of epoxy to the other side of the
hinges on the horizontal wing. Remember to keep the hinge
points clear of epoxy.
Step 6. Insert elevons onto wing.
Assembling the Main Wing and Servos