Required additional equipment kit contents, Tools and supplies needed (not included in kit), Not included in kit) – E-flite ElectraJet EP w/ESC & Delta Mix User Manual

Page 3: Recommended radio and electronic equipment

Tools and Supplies Needed
(not included in kit)

• Sharp hobby knife
• Double-sided servo tape
• Round file (small)
• Velcro

Tape

• Needle-nose pliers
• Masking tape
• Wire cutters
• Black felt-tipped pen or pencil
• Phillips screwdriver
• Flat-head screwdriver (medium)

not included in kit)

• 1.5mm Allen wrench
• Sanding block with fine grit sandpaper
• Ruler
• Drill
• Drill Bit: 1/8"
• 12-minute epoxy
• Rubbing alcohol
• Odorless CA
• Clear silicone sealant

Recommended Radio and

Electronic Equipment

The best choice for your airborne radio equipment would be
the JR AirPac Micro (JRPF640), which combines two JR S241
Sub-Micro servos and one JR R610 6-channel FM micro receiver
into one package. Total weight for this three-piece
package is just over one ounce.

An 8-cell 600mAh battery pack

A speed controller is included in the kit, as is the V-tail mixer
in the deluxe kit (EFLA1000). The best choice for your speed
controller is E-Flite 16-Amp Electric Speed Control (EFLA100).
If you do not have a radio that has delta mixing capabilities,
you can purchase a Delta Mixer for the standard kit (EFLA101).

Required Additional Equipment

Kit Contents

Carefully examine the contents of this kit before you start the
assembly process. It is recommended that you carefully read
through this instruction manual before you start assembly.

Fuselage
Canopy
Motor Cover
Left Wing Panel
Right Wing Panel

Vertical Fins (2)
Everons (2)
Hardware Package
Canopy hatch
Dorsal Fin

Speed Controller
(EFLA100)
Delta Mixer (EFLA101)
Motor + Gearbox
Prop Nut

Set Screw
Propeller

1
2
3
4
5

12
13