E-flite ElectraJet EP w/ESC & Delta Mix - Manual (Page 10)

10
Step 1. Locate the spinner, aluminum nut, set screw, and
propeller from the kit contents.
Step 2. When you insert the nut into the propeller, the printing
on the 8"x4" propeller must face toward the gearbox of the
motor when it is mounted to the motor.
Step 3. Use a propeller wrench to secure the spinner, aluminum
nut, and propeller to the propeller shaft.
Step 4. Use the 1.5 mm hex wrench to tighten the grub screw
of the aluminum nut to the propeller shaft of the motor/gearbox
(please note that the set screw will thread onto the flat spot on
the shaft).
Step 5. Secure the motor to the motor mount on the fuselage
with the four small rubber bands provided.
Step 6. Secure the cowling of the motor to the motor mount
with several small rubber bands.
Assembling the Motor and Propeller