beautypg.com

E-flite ElectraJet EP w/ESC & Delta Mix User Manual

Page 5

background image

5

Step 7. Please locate the indentations made on the elevons for
the control horns. Install the control horns to the elevons using
12-minute epoxy. Allow the epoxy to cure completely.

Step 8. Locate two micro servos and two sets of pushrod connectors.

Step 9. Attach double-sided servo tape to each of the micro servos.

Step 10. Use a 2.0-mm drill bit to open up the holes in the
servo arm of each servo.

Step 11. Insert the pushrod connectors into the holes in the
servo arms, but do not tighten the servo arm down at this time.

Step 12. Allow the connectors to be free to move.

Step 13. Using a wire cutter or metal snip, trim the excess
plastic away from the servo control arm on each servo. A sharp
hobby knife will also work.

See also other documents in the category E-flite Air equipment: