E-flite ElectraJet EP w/ESC & Delta Mix - Manual (Page 12)

12
Step 1. Make sure the power switch is off and that the battery is
not connected before you connect the motor and speed control plug.
Warning: Always assume the motor can come on at
any time. Be absolutely certain no power is connected
to the motor while you are working around it.
Step 2. Now is the time to install the bottom vertical fin with
odorless CA, as shown in the picture below.
Step 3. Connect the servo leads to the delta-mix connectors
located near the fuselage.
Step 4. Fix the antenna cable on the main wing with the 10 mm
sticker tape provided. This sticker tape is located on the decal
sheet and is grey in color. This decal will have to be cut into
three strips as it will be used to cover the servo leads and the
receiver antenna.
Step 5. Fix the servo wires to the wing with the 10 mm sticker
tape provided
Step 6. Use the box as a reference when applying the decals to
the aircraft.
Step 7. Check the center of gravity of your model. Place the
battery pack inside the fuselage so that the model will balance
properly. When the desired location is found, place the battery
inside the canard using double-sided servo tape. Please note
that the battery mounts between two pieces of foam which are
molded into the fuselage. These two pieces may have to be
trimmed depending on the battery of your choice.
Assembling the Tail Fin and Servo Connectors