E-flite Nieuport 17 250 ARF - Manual (Page 8)

8 E-flite Nieuport 17 Slow Flyer Assembly Manual
 8. Use a pencil to trace the outline of the fuselage
on the bottom of the stabilizer. You will only need
to mark one side of the stabilizer in this step so you
can return the stabilizer to the correct alignment on
the fuselage.
 9. Remove the stabilizer from the fuselage. Apply
foam-safe CA to the fuselage where the stabilizer
fits. Using the line drawn on the bottom of the
stabilizer, reposition it on the fuselage. If the stab
saddle is flat you will still need to sand the paint off
this area before gluing the stab in place. Hold the
stabilizer tightly against the fuselage until the CA
fully cures.
Rudder Installation
Required Parts
Fuselage assembly CA hinge
Rudder
Micro control horn Micro control horn backplate
Required Tools and Adhesives
Felt-tipped pen Hobby scissors
Foam-safe CA Hobby knife w/#11 blade
Please follow the procedure as illustrated for
hinging the rudder. Trying to trim the hinge for
the control horn after it has been glued in the
rudder can cause damage to the rudder.
 1. Insert the CA hinge in the slot in the rudder.