beautypg.com

Preflight, Range test your radio, Flying your nieuport 17 slow flyer – E-flite Nieuport 17 250 ARF User Manual

Page 23

background image

23

E-flite Nieuport 17 Slow Flyer Assembly Manual

Preflight

Check Your Radio

Before going to the field, be sure that your batteries

are fully charged per the instructions included with

your radio. Charge both the transmitter and receiver

pack for your airplane. Use the recommended charger

supplied with your particular radio system, following

the instructions provided with the radio. In most cases,

the radio should be charged the night before going

out flying.

Before each flying session, be sure to range check your

radio. See your radio manual for the recommended

range and instructions for your radio system. Each

radio manufacturer specifies different procedures for

their radio systems. Next, start the motor. With the

model securely anchored, check the range again.

The range test should not be significantly affected. If

it is, don’t attempt to fly! Have your radio equipment

checked out by the manufacturer.

Keep loose items that can get entangled in

the propeller away from the prop. These

include loose clothing, or other objects such

as pencils and screwdrivers. Especially keep

your hands away from the propeller.

Double-check that all controls (aileron, elevator, rudder

and throttle) move in the correct direction.

Check the radio installation and make sure all the

control surfaces are moving correctly (i.e. the correct

direction and with the recommended throws). Test run

the motor and make sure it transitions smoothly from

off to full throttle and back. Also ensure the engine is

installed according to the manufacturer’s instructions,

and it will operate consistently.

Check all the control horns, servo horns, and

clevises to make sure they are secure and in good

condition. Replace any items that would be considered

questionable. Failure of any of these components in

flight would mean the loss of your aircraft.

Range Test Your Radio

1. Before each flying session, be sure to range

check your radio. This is accomplished by turning

on your transmitter with the antenna collapsed.

Turn on the receiver in your airplane. With

your airplane on the ground and the engine

running, you should be able to walk 30 paces

(approximately 100 feet) away from your airplane

and still have complete control of all functions.

If not, don’t attempt to fly! Have your radio

equipment checked out by the manufacturer.

2. Double-check that all controls (aileron, elevator,

rudder and throttle) move in the correct direction.

3. Be sure that your transmitter batteries are

fully charged, per the instructions included with

your radio.

Flying Your Nieuport 17 Slow Flyer

You will find the Nieuport 17 Slow Flyer Slow Flyer to

be a solid, honest-flying model.

Ensure your CG is set according to the manual and

power up the aircraft. Move your throttle trim up slowly

until the motor just begins to spin. This will be your

flight idle that will help to establish a longer glide path

and tends to make landings easier. Before taxiing out

to the runway, double-check all controls are working in

the correct direction and functioning properly. You will

find the rudder very effective; on the ground, tracking

is very predictable. Apply power smoothly and begin

the takeoff roll. Correct with rudder as necessary and

apply up elevator slowly until the model lifts off.

You will find flying the Nieuport 17 Slow Flyer to be

very relaxing and easy. The model is not designed for

high speed flight. Most flight is accomplished below

half throttle and will yield flights in excess of 20

minutes with an 800mAh 2-cell battery with a Park

250 when outfitted with the GWS 7x3.5 prop. Landing

the Nieuport 17 Slow Flyer Slow Flyer is as easy as

setting up on final approach, lowering the throttle to

idle and gliding in to a soft touch-down.

You will find the Nieuport 17 250 Slow Flyer

capable of basic loops and stall turns. Flying these

maneuvers is easy and fun with the Nieuport 17

250 Slow Flyer. After your first flight you will want

to check your rigging to make sure none of the

locations that were glued with CA have loosened.

Check these areas on a regular basis to ensure safe

and reliable operation.. We hope you enjoy the

experience of flying the Nieuport 17 Slow Flyer.

Happy landings.