E-flite Nieuport 17 250 ARF - Manual (Page 20)

20 E-flite Nieuport 17 Slow Flyer Assembly Manual
 11. The rigging now heads to the rear hole in the
outer strut. Again, this line will be between the
current rigging lines.
 12. Route the rigging up and to the forward hole in
the outer strut.
 13. The rigging now goes down and through the
forward tube in the fuselage. This line will be in
front of all the other rigging lines.
 14. After exiting the fuselage, route the rigging up
to the forward hole in the outer strut. Make sure
the rigging is in front of all the previously installed
rigging lines.
 15. To complete the first stage of rigging, route it
down and forward through the hole the rigging
originally started at. Leave the end of the rigging
loose at this time and do not tie it to the strut.
 16. Use the following images to verify the rigging
installation. The lines heading upward from the
fuselage to the outer struts should be on the
outsides (front and back) of the downward lines.
When tensioned, the lines will all run perfectly
straight and not cause others to be moved out of
position.